Turning Spyball Functions on and off

spyball-motorcycle-alarm

Some of the features on the Spyball 6829 can be turned on and off with the remote. Here is a quick video running through how to select each function, then activate or de-activate each one.

Procedure:

  • While the security system is disarmed, turn ignition on, press and hold down push-button 1 of the transmitter about 7 seconds, until the LED lights up, then release.
  • The LED remains on about 3 seconds.
  • During this lapse of time, press push-button n. 1 again.
  • A short sharp audible signal confirms that the procedure has been initiated. The LED switches off, and then provides five different visual indications that relate to the five selectable functions.
  • Please refer to the list below:

Functions 1 to 5

1: Biker Recognition: Arms/Disarms alarm as the remote comes into proximity of the bike.Press push-button 1 of the transmitter after the first flash to select. Three sharp audible signals follow to confirm Biker Recognition is turned on.Press push-button 2 of the transmitter after the first flash to deselect. One sharp audible signal follows to confirm Biker Recognition is turned off.


2: Arming and disarming audible signals: Chirps when arming/disarming alarm.Press push-button 1 of the transmitter after the second flash to select audible arm/disarming. Three sharp audible signals follow.

Press push-button 2 of the transmitter after the second flash to deselect. One sharp audible signal follows to confirm chirp de-selection.


3: “Turn indicator on” audible warning signal: Chirps the siren to warn the rider if the indicators have been left on for more then 24 seconds.

Press push-button 1 of the transmitter after the third flash to select. Three sharp audible signals follow.Press push-button 2 of the transmitter after the third flash to deselect. One sharp audible signal follows.


4: Anti-hijack function: Will trigger the alarm after 2 minutes if the rider leaves the bike whilst the ignition is on.

Press push-button 1 of the transmitter after the fourth flash to select Anti Hijack. Three sharp audible signals follow.Press push-button 2 of the transmitter after the fourth flash to deselect. One sharp audible signal follows.


5: No not adjust: (for dealer use only)

vehiclesecurity.co.nz-home

Share
Julian

About Julian

Owner and Installer at Obsessive Vehicle Security Limited. More details here... Please keep Comments relevant to the post and use the Contact form for enquiry's
This entry was posted in Bike alarms, Programming Tools, Spyball and tagged . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.